GutterHawk Roofing & Gutter Specialists
A lot of the back porches along Timberlane Road were built as open slabs decades before anyone thought to screen them in, which means the framing has to be added, not just re-covered. If your existing screen porch is sagging at the corners or the mesh has gone soft from years of pine sap and pollen, that’s usually the frame telling you it was never sized for the load it’s carrying now.
This page covers screen porch work specifically: new screen enclosures built onto an existing patio or slab, full rescreens of porches that already have a frame, and repair of frame members, screen spline, and door hardware. It does not cover roofing over the porch structure or gutter work tied to the porch roofline, those are separate jobs with their own scope even when they happen on the same visit.
A screen porch build starts with the frame. We use aluminum or wood framing depending on what the existing structure calls for and what matches the house, then run screen material sized to keep out no-see-ums as well as the bigger flying insects that come off the tree line in the evenings. Doors get real hinges and a closer, not just a screen flap. If you’re rescreening an existing porch, we pull the old screen and spline, check every frame member for rot or corrosion before we re-tension anything, and replace what’s failed instead of screening over a bad frame.
Timberlane sits north-central, off Timberlane Road, in an area with a mix of housing stock that ranges from older brick ranch homes to newer construction further out toward the Thomasville Road corridor. The older homes tend to have low-pitch composition shingle roofs and shallow overhangs, which means porches attached to those roof structures often deal with more direct runoff at the roofline where it meets the porch frame. Newer builds in the area generally have steeper pitches and better-managed drainage, but the framing still has to tie into the existing roof edge cleanly, and that detail matters more than people expect when a porch is added after the fact.
The tree canopy here is heavy, mostly pine, and that changes the maintenance math on a screen porch more than most homeowners realize. Pine needles and sap don’t just clog gutters, they collect against screen mesh and against the bottom track of sliding screen doors, and sap that dries onto screen material is hard to clean off without stretching or tearing it. Grade and drainage around slabs vary lot to lot in this part of Timberlane, so standing water at the base of a porch frame is something we check for on every job, since a frame sitting in water year-round corrodes or rots faster than one that drains. Some sections of the neighborhood may fall under an HOA with rules on exterior additions, screen color, or enclosure style, so confirm your covenant requirements before we finalize a design, we build to what the homeowner approves and don’t assume there’s no review process.
On day one, the crew walks the porch or patio slab with you, checks the existing frame or roofline it will tie into, and confirms measurements against what was quoted. For a new build, we lay out post and header locations before anything gets fastened, so you can see where doors and sightlines will land. For a rescreen, we start pulling old screen and spline section by section rather than stripping the whole porch at once, which keeps the structure protected if weather rolls in mid-job, and Timberlane afternoons in summer are not something we schedule around casually.
Framing and fastening happen next, then screen material is set into the spline channel and tensioned. Doors get hung and adjusted last, once the frame has taken its final set. Debris, old screen, and cut-offs get bagged and hauled, we don’t leave that in your yard. What we need from the homeowner: clear access to the porch area, any HOA approval already in hand if it applies, and a decision made ahead of time on screen density and frame color, since that’s harder to change once material is ordered.
Screen porch work in Timberlane runs {PRICE_LOW} to {PRICE_HIGH}, and the spread comes down to a few things. A straight rescreen on an existing sound frame costs less than a new enclosure built from scratch. Frame material matters too, aluminum framing prices differently than wood, and if the existing frame has rot or corrosion that has to be replaced before screening goes on, that adds labor and material you won’t see on a healthy frame. Porch size, number of doors, and screen density (standard versus no-see-um mesh) also move the number. We walk the site and give you a firm figure before work starts, not a phone estimate.
GutterHawk works out of two Timberlane locations, Shamrock and North Monroe, which keeps scheduling short across the city and out into Leon County. Both teams build screen porches in Timberlane FL to the same standard. We cover Killearn, Killearn Lakes, Betton Hills, Midtown, Downtown, Myers Park, Maclay, Bobbin Brook, Live Oak Plantation, Timberlane, Woodgate, Foxcroft, Bull Run, Apalachee Ridge, Ox Bottom, Golden Eagle, Southwood, Buck Lake, and Havana.
Whether it is a rescreen or a build from scratch, the sooner it is done the more of the season you get out of it. Call GutterHawk at 850-779-1081 for screen porches in Timberlane FL.
Q.1 How long does the screen last here?
Roughly five to ten years, depending on sun exposure and whether pets use it.
Q.2 What screen keeps out no-see-ums?
No-see-um mesh, which has a much tighter weave than standard fiberglass screen.
Q.3 Can I enclose my existing patio?
Usually yes, and it costs far less than building new since the slab and roof already exist.
Q.4 Do I need a permit?
Generally yes for new structures. We handle Leon County permitting as part of the job.
Q.5 How long does a build take?
A rescreen is a day or two. A full build is typically one to three weeks depending on scope.
Q.6 Can you add power and fans?
Yes, coordinated with a licensed electrician as part of the project.
Q.7 How much do screen porches in Timberlane FL cost?
Rescreening is modest. Conversions cost less than new builds. We quote itemised after a site visit.
Getting the process started is easy! Simply fill out our quick form or call us at 850-656-4295. One of our friendly staff members will get in touch to finalize the details.
One of our expert estimators will get to to work analyzing your job and crafting a proposal. Of course, we’re here to answer any questions you may have.
Have questions about your roof? Do you need information on gutter maintenance plans? No matter the question, GutterHawk is here to help!