Do you bid off our plan set or do a site visit first?

Both. We price off your stamped plans and spec sheet, then confirm scope on site once the pad is cleared and framing is set, since field conditions on a graded Meridian Hills lot don't always match the plan sheet exactly.

Can you keep pace with a phased subdivision release?

Yes. We schedule crews to your framing handoff sequence rather than one-lot-at-a-time, and we quote phased pricing once we know the model mix you're releasing.

Will you handle the HOA color and material approval?

We'll confirm your spec matches the approved architectural palette before ordering material, but the approval submission itself runs through your team or the developer, since we're not a party to that HOA agreement.

How do you document work for draw inspections?

We photograph dry-in, flashing, and fastening at each stage and tag it to the address and lot number so it drops straight into your draw package without extra formatting on your end.

What happens if a lot's grading isn't finished when the roof goes on?

We install the roof to the plan's drainage design and flag any visible grading concern to your superintendent, since final swale grading is typically a separate scope from the roof itself.

Do you work with our engineer of record if there's a field change?

Yes. Any deviation from the stamped plan gets routed through your EOR for a written change before we install it, rather than us making a field call on structural or flashing details.

New Construction Roofing in Meridian Hills, FL

Meridian Hills sits on the north block of the county, where the last decade of building has pushed new lots into pine stands that were standing timber a few phases earlier. Every roof going up here has to reckon with the same site condition: cleared pads ringed by mature pine, sandy fill graded fast for a closing date, and inspectors who know that combination well enough to look twice at drainage details before they sign off.

What We Cover on a Build

Dry-in — underlayment and temporary weather protection as soon as the deck is on, so interior trades can start without weather risk.
Full roof installation — shingle, metal, or tile, installed to the plans and the manufacturer specification.
Flashing and penetration detailing — chimneys, valleys, sidewalls, vents, and anything the mechanical or plumbing trades put through the deck.
Ventilation — ridge and soffit systems sized to the attic volume rather than whatever fits.
Gutters, fascia, and soffit — the whole roofline from one subcontractor, which removes a coordination problem from your schedule.
Additions and remodels — tying new roof structure into existing, where the transition detail is the part that leaks if it is rushed.
Multi-unit and spec builds — repeat work across a development, priced and scheduled as a programme rather than one house at a time.

Working to a Construction Schedule

New Construction Roofing in Meridian Hills

This page is written for builders and general contractors managing roof scopes on new builds in Meridian Hills, not for a homeowner replacing a roof on an existing house. If that’s you, our new construction roofing hub covers the service across Leon County.

We work off your plan set and spec sheet, not a generic bid template. That means matching underlayment class, fastening schedule, and flashing details to what’s called out, and documenting it the way your draw inspector wants to see it. We coordinate with your superintendent on sequencing so roof-in doesn’t stall a dry-in milestone, and we build a stack of photos and material tags for the file before the crew leaves the site.

Work is performed to the applicable Florida Building Code 7th Edition provisions for the roof assembly type on your plans. We don’t quote uplift numbers or wind ratings as a marketing point on this page. Your engineer of record and the plans set those figures; our job is to install to them and hand you the paperwork that proves it.

For subdivision-scale work we can run multiple addresses on a rolling schedule, which matters when your framing crews are handing off lots in sequence rather than one house at a time. We staff to keep pace with that handoff instead of making your schedule wait on us.

Building to Florida Code

What Meridian Hills homes are dealing with

Most of the roof structures going up in Meridian Hills right now are conventional truss systems at moderate pitches, sheathed with OSB and finished in architectural shingle, with a smaller share of standing seam on higher-end elevations. Some phases of the neighborhood carry an HOA architectural review that dictates roof color and material within a set range, so we confirm the approved palette against your spec before ordering shingle so a delivery doesn’t sit on a lot waiting for a resubmittal.

The pine canopy on the north block is the site condition that shapes our scheduling more than anything else. Cleared lots still sit close to standing timber, and pine straw and sap drop onto exposed decking during dry-in, which means we sequence underlayment installation to close that window fast rather than leaving a deck open over a weekend. Grading on newer pads is often still settling, so we check finished roof drainage against the site plan’s swale layout before we set gutters, since a roof built to spec on a lot that’s still consolidating can end up shedding water toward a low corner that wasn’t low when the plans were drawn.

The New Construction Roofing in Meridian Hills FL Process

How the job runs

Day one starts with a plan review meeting on site, not a walkthrough after material’s already been dropped. We confirm truss layout, penetration locations for HVAC and plumbing stacks, and any valley or hip conditions against the roof plan sheet, and we flag anything that doesn’t match field conditions before dry-in begins.

Dry-in and underlayment go down first, photographed and tagged for your draw package. Flashing at walls, chimneys, and penetrations follows to the manufacturer’s installation instructions for whatever system is specified. Field material goes on last, with fastening pattern checked against the wind zone requirement on your plans rather than a default pattern we’d use on a repair job.

What we need from you: a current, stamped plan set, confirmation of the approved shingle or metal color if the HOA governs it, and a point of contact on your team who can answer a field question same-day. Draw inspection timing should be communicated as early as possible so we can stage the crew around it instead of working around a surprise hold.

Why the Roof Detail Matters More on New Builds

What it costs

New construction roofing on a single-family lot in Meridian Hills typically runs {PRICE_LOW} to {PRICE_HIGH}, and that range moves on roof complexity, material (architectural shingle versus standing seam), pitch, and total square footage. Multi-lot subdivision pricing is quoted per phase once we’ve seen the plan set for the model types involved, since a repeated floor plan lets us price tighter than a one-off custom roof. We don’t publish a flat number here because no two plan sets carry the same penetration count, valley length, or flashing detail, and quoting one figure across the board would be a guess, not a bid.

What New Construction Roofing Costs

Common questions

Serving Meridian Hills From Two Locations

GutterHawk works out of two Meridian Hills locations, Shamrock and North Monroe, covering new construction across the city and out into Leon County. Both teams handle new construction roofing in Meridian Hills FL to the same standard, including Southwood, Killearn Lakes, Ox Bottom, Golden Eagle, Buck Lake, and the developments out toward Havana.

Get Priced From Your Plans

Send us the drawings and we will give you a number and a date. Call GutterHawk at 850-779-1081 for new construction roofing in Meridian Hills FL, or ask us to quote a full development rather than one lot.

Frequently Asked Questions

Q.1 Can you price from plans before the frame is up?

Yes. Send the drawings and we will do a takeoff and give you a fixed price.

Q.2 How quickly can you dry in after the deck is on?

Usually within days, weather permitting. We schedule it against your programme in advance.

Q.3 Do you handle gutters and soffit as well?

Yes. The whole roofline from one subcontractor, which is one less trade to coordinate.

Q.4 Do you do multi-lot developments?

Yes, and repeat work across a development is priced better than one-off jobs.

Q.5 Who handles permitting and inspections?

We pull our own permits and attend the roof inspection.

Q.6 Does the warranty transfer to the homeowner?

Yes. Our written workmanship warranty transfers, alongside the manufacturer coverage.

Q.7 How much does new construction roofing in Meridian Hills FL cost?

We price from drawings, so you get a fixed number rather than an allowance that moves later.

Ready To Get Started?

Working With Us Is Easy

01. Request Your Quote

Getting the process started is easy! Simply fill out our quick form or call us at 850-656-4295. One of our friendly staff members will get in touch to finalize the details.

02. We Work On Your Estimate

One of our expert estimators will get to to work analyzing your job and crafting a proposal. Of course, we’re here to answer any questions you may have.

03. GutterHawk Gets To Work!

You can rest assured that the most capable professionals using the best quality materials are diligently working on your home. It’s why Meridian Hills trusts GutterHawk!

Ready To Get Started?

Contact Us

Have questions about your roof? Do you need information on gutter maintenance plans? No matter the question, GutterHawk is here to help!

Killearn Estates

Killearn Acres

Bradfordville

Betton Hills

Lafayette Park

Southwood

Killearn Lakes Plantation

OX Bottom Manor

Summerbrooke

Golden Eagle

Foxcroft

Bull Run

Waverly Hills

Buck Lake Mahan

Piney-Z

Apalachee Ridge Estates

Myers Park

Maclay

Bobbin Brook

Live Oak Plantation

Timberlane

Woodgate

Lake Jackson

Meridian Hills

Midtown

Downtown Tallahassee

Havana